Specifications

Part 6 Gas Conversion

Gas Regulator

NOTE:

The regulator supplied is convertible between Natural

Gas and LPG, but it’s outlet pressure is fixed

ex-factory and is NOT to be adjusted.

1. Ensure that the gas supply is turned ‘OFF’ at the

mains.

2. Unscrew the hexagonal cap (23 mm A/F) from the

regulator.

3. Un-clip the plastic pin from the cap, rotate the pin

and re-fit it back into the cap the correct way for

the gas type to be used. (Either ‘LP’ or ‘NAT’

should be visible on the flank of the pin once

re-fitted to the cap).

4. Screw the cap back into the regulator hand tight

only.

Gas Type Identification Label

On completion of the gas conversion, replace the

gas type labels located at:-

- The rear of the unit, above the gas connection.

- Beside the rating plate.

NOTE:

If for some reason it is not possible to get the

appliance to operate correctly, shut off the gas supply

and contact the supplier of this appliance.

NOTE, Pin rotated

for Natural Gas

NOTE, Pin

rotated for LPG