Specifications

11
Part 6 Gas Conversion
Gas Conversion Procedure
NOTE:
 These conversions should only be carried out
by qualified persons. All connections must be
checked for leaks before re-commissioning
the appliance.
 For all the following conversion instructions,
the side panels have to be removed (Remove
the two screws at the bottom of each side
panel).
 All conversion details apply to both L/Hand
and R/Hand burners.
 For all relevant gas specifications refer to the
table at the end of this section.
Main Burner Injectors
1. Ensure that the gas supply has been turned 'Off'.
2. Unscrew the main burner injectors (½” A/F).
3. Determine the correct injector sizes for the
corresponding gas type from the rating plate
affixed to the right hand side panel front bottom
corner.
4. Replace with the correct size injectors.
C AUTION :
Ensure that the Unit is isolated from the gas
supply before commencing servicing.
Main Burner
Injector
Low Fire Adjustment
1. Remove the gas control knobs from the front of
the unit.
2. Remove the 2 front control panels by removing
the two screws (per panel) located at the
bottom of each panel.
3. Set the burner low fire adjustment. The low fire
screw on the gas control valve should be
screwed fully in, then unscrewed by the
measurement shown in the ‘Gas Specifications’
table.
NOTE:
The ‘Low Fire Screw’ should be sealed with
coloured paint on completion of the low fire
adjustment.
Commissioning
Before leaving the converted installation;
1. Check all gas connections for leakages using
soapy water or other gas detecting equipment.
2. Check the following functions in accordance
with the operating instructions specified in the
‘Operation’ section of this manual.
 Light the Main Burners.
 Check the Low Fire burner operation.
 Check the High Fire burner operation.
 Ensure all controls operate correctly.
NOTE:
If for some reason it is not possible to get the
appliance to operate correctly, shut off the gas
supply and contact the supplier of this unit.
Low Fire
Adjust-
WARNING:
DO NOT USE A NAKED FLAME TO CHECK FOR GAS
LEAKAGES.