Operation Manual

1). Make sure the chain brake level is disengaged; (See Fig. 1a)
2). Place the chain saw on any suitable flat surface;
3). Plug the unit into the power source;
4). Grasp the front handle with your left hand. Thumb and fingers should encircle the
handle;
5). Grasp the rear handle with your right hand. Thumb and fingers should encircle the
handle;
6). Press the lock-off button with your right thumb, then fully press the switch trigger with
your index finger and hold in this position;
7). While the motor is running, activate the chain brake by rolling your left hand
forward against the chain brake lever; (See Fig. 1b);
8). Chain and motor should stop immediately.
NOTE: The motor will not start if the chain brake lever is in the engaged position.
WARNING: To reduce the time of exposure to vibration and noise, it is preferable to use
the machine with frequent breaks, and limiting the duration of continuous work.
WARNING: The vibration level during actual use of the chainsaw may differ from the
declared depending on what material is being cut with different factors of stem diameter ̀
density and fibre composition to name a few.
The chain brake is a safety mechanism activated through the front hand guard. When
kickback occurs, the chain stops immediately through inertia. The following function
check should be carried out at regular
intervals. The purpose of the chain brake testing
is to reduce the possibility of injury due to kickback.
2.3.1 CHAIN BRAKE.
WARNING! If the chain and motor fail to stop when the chain brake is engaged,Stop
using immediately take the saw to the nearest authorised dealer. Do not use the saw if
the chain brake is not in proper working order.
CAUTION! The chain brake lever should not be used for starting
and stopping the
saw during normal operation.
1a 1b
10