Operation Manual
Instruction Manual / 11
- Reset the gripping teeth at a low point when sawing thicker logs by pulling the chain
saw slightly backwards until the gripping teeth release, and reposition at lower level
to continue sawing. Do not remove the saw completely from the wood.
- Do not force the chain while cutting, let the chain do the work, using the gripping
teeth to apply minimal leverage pressure.
- Do not operate the chainsaw with arms fully extended or attempt to saw areas which
are difficult to reach, or on a ladder. Never use the chainsaw above shoulder height.
(See Fig.3c)
- Sawing is optimis
ed when the chain speed remains steady during cutting.
-
Beware when reaching the end of the cut. The weight of the saw may change
unexpectedly as it cuts free from the wood. Accidents can occur to your legs and
feet. Always remove the saw from a wood cut while the saw is running.
2.3.5 CUTTING LOGS.
Observe the following safety instructions:
- Support logs so that the face sides at the cut do not
close in against each other, which would result in the
chain being jammed or pinched. (See Fig.3a, Fig.4)
The chain must be running at full speed before it makes contact with the wood. Use the
metal gripping teeth to secure the saw onto the wood before starting to cut. Use the
gripping teeth (12) as a leverage point while cutting. (See Fig.3b)
3b
3c
4