Operation Manual

5. Problems and solutions.
Malfunction
Probable cause Troubleshooting
The unit does not start
There is no current
Check the power source.
If necessary, change the source
Check the condition of the cord or
plug. If they are damaged, change
them.
The recoil brake is
triggered
Arm the security system
pulling the hand guard to the handle
upwardly
The carbon brushes are
worn
Please contact your local dealer
The switch is faulty or
defective
Please contact your local dealer
The electric chainsaw
works intermittently
The power cord is
damaged
Please contact your local dealer
The switch is faulty or
defective
Please contact your local dealer
The chain is dry No oil in the tank
Fill with correct oil
The tank cap vent
is clogged with oil
Wipe the top of the oil tank
The oil flow channel is
clogged
Drain the oil tank and clean the
compartment under the cap
The chain brake does
not work
Problem with the
mechanism starting at the
hand guard
Please contact your local dealer
Chain derails from the
chain guide,
generates vibration or
won't cut correctly
Problem with the
mechanism starting at the
hand guard
Please contact your local dealer
Chain heats up
excessively
The chain is too tight. Re-tension chain