Operation Manual

3.2 Using the chainsaw

Before use, make sure that you have the correct safety equipment and that the plug

and lead are in

good working order. Also check the status of the chain and the chain

guide and the fixing system. If necessary, replace or repair defective components.

Use only original parts approved by Cobra Garden.

3.2.1 Starting chainsaw

WARNING: Never work with a guide bar and a damaged or excessively worn

hain as this may cause personal injury.

WARNING! Check the voltage and current supply. The voltage and current

supply must comply with the ratings on the type plate.

WARNING! Ensure the extension cord is of the proper size and type for your

saw (≥1.5mm

)

1). Make sure the chain brake lever (1) is disengaged. Th

e motor will not start if the

chain brake is in the engaged position. Disengage the

chain brake lever by

pulling backward toward the front handle. (See Fig. 16).

2). Grip the product with both hands, left hand holding the front handle (do not hold chain

brake) and the right hand holding the rear handle. Press the lock-off button (5), then

fully press the switch trigger (6) and hold in this position. The lock-off button can now

be released now. (See Fig. 17a, 17b).

NOTE: It is not necessary to maintain pressure on the lock-off button once the switch

trigger is squeezed and the motor is running. The lock-off button is a safety device to

avoid accidental starting.

17a

17b