Operation Manual

WARNING! The chain saw is not supplied lled with oil. It is essential to ll
with oil before use. Never operate the chainsaw without chain oil or at an
empty oil tank level, as this will result in extensive damage to the chainsaw.
Never starve the bar and chain of lubrication oil. Running the saw dry or with
too little oil will decrease cutting efficiency, shorten chain saw life, and
cause rapid wear of the chain and excessive wear of the bar from
overheating. Too little is evidenced by smoke or bar discoloration.
WARNING! To allow venting of the oil reservoir, small breather channels
are provided between the oil filler cap and the strainer, to prevent leakage
ensure machine is left in a horizontal position (oil filler cap uppermost) when
not in use. It is important to use only the recommended oil to avoid damage
to the chain saw. Never use recycled/old oil. Use of non approved oil will
invalidate the warranty.
CAUTION! The oil tank level should be frequently checked during operation
to avoid starving the bar and chain of lubrication.
Adequate lubrication of the saw chain during cutting operations is essential to minimize
friction with the guide bar. your chainsaw is equipped with an automatic oiler system. The
oiler automatically delivers the proper amount of oil to the bar and chain.
The oil tank holds 210mI of oil, enough to lubricate the chain for 20-25 minutes of cutting.
The oil tank level can be checked through the chain lubricant tank inspection window (10)
provided on the right side of the saw. (See Fig.15)
3.1.3 CHAIN AND BAR LUBRICATIPON
Filling oil tank:
1). Set the chain saw on any suitable surface with the oil filler cap (C) facing
upward. 2). Clean
the area around the oil filler cap with the cloth.
3). Add chain saw oil until the reservoir is full.
4). Avoid dirt or debris entering the oil tank, refit the oil filler cap and tighten.
NOTE: Your chain saw is equipped with an Automatic Oiler system and is the only source
of lubrication for the bar and saw chain.
15