Warranty

Wires alignment
Battery connector
1
2
Holster
Backlit LCD Display
Features
• 22 Channels
• 121 Privacy Codes
(38 CTCSS codes/
83 DCS codes)
• Hands-Free Operation
(VOX)
• Backlit LCD Display
• Call Alert
• Button Lock
• Speaker/
Microphone/
Charge Jack
• Roger Beep
• Battery/Power Saver
• Keystroke Tones
• Battery Level
Indicator
• Low Battery
Audible Alert
• Auto Squelch
• Holster
1 2
Caring for Your microTALK
®
Radio
Your microTALK
®
radio will give you years of trouble-free service if cared for
properly. Handle the radio gently. Keep the radio away from dust. Never put
the radio in water or in a damp place. Avoid exposure to extreme
temperatures.
Installing Batteries
1. Remove Holster by releasing the belt clip latch and
slide the holster downward.
2. Unscrew 2 screws at bottom with a proper
screwdriver, then open the battery compartment
cover. Connect the connector of the battery to the
socket of the radio inside the battery compartment.
3. Place the battery inside the battery compartment and
align the wire as shown.
(Make sure the wire does not block the screw holes)
4. Replace the battery compartment cover, screw down
the screws mildly.
(Screw nuts may be damaged if applying too strong
force when tightening)
5. Re-attach the holster
To charge batteries in radio:
1. Check to see that the batteries have been
inserted properly.
2. Insert the cable into the charge jack located at
the left side of the radio.
3. Plug the cable into USB-compatible power port.
Only use the supplied rechargeable batteries and desktop charger for
recharging your Cobra microTALK
®
radio.
Cobra recommends your radio is turned off while being charged.
1
2
3
4
5
10
11
9
7
8
6
1. Lock Icon
2. Transmit Icon
3. Receive Icon
4. Battery Level Indicator
5. VOX Icon
6. DCS Icon
7. CTCSS Icon
8. DCS / CTCSS Privacy
Code Numbers
9. Power Saver Icon
10. VibrAlert Icon
11. Channel Numbers
Battery Door Screws