Warranty

Battery Low
When battery power is low, the nal bar in the
Battery Low icon will blink and an audible tone will
sound twice before the radio shuts off. Your batteries
need to be recharged.
Auto Battery Save
If there are no transmissions within 10 seconds, the
radio will automatically switch to Battery Save mode
and the Power Saver icon will ash in the display.
This will not affect the radio’s ability to receive
incoming transmissions.
Communicating with Another Person
1. Press and hold the Talk button.
2. Position the microphone about two inches (5 cm)
from your mouth, speak in a normal voice.
3. Release the Talk button when you are
nished talking and listen for a response.
You cannot receive incoming calls while
pressing the Talk button.
To Select a Channel
Press Mode button once, then press Up button or
Down button.
3 4
Battery Low
Two Inches
from Mouth
The radio will display ashing battery icon
while charging if the radio is on.
Both radios must be tuned to the
same channel to communicate.
See page 11 for frequency
allocations charts.
Listening for a Response
Release the Talk button to receive incoming
transmissions. Your microTALK
®
radio is always
in Standby mode while the Talk or Call buttons
are not pressed.
Up & Down Button
Battery Save Mode
Talk Button
Channel Number
Listening
Operation
Using Your Radio
Turning on Your microTALK
®
Radio
Turn clockwise to turn the radio on and counterclockwise to turn the
radio off.
1. In the ON position, the radio chirps and briey shows all feature icons
available on the radio.
2. The display screen then shows the current channel, code and all features
that are enabled.
Quick Start
1. Turn On/Off VOL Knob clockwise to turn the radio on and counter
clockwise to turn the radio off.
2. Select a desired channel.
3. Press and hold the Talk button while speaking into the microphone.
4. When nished talking, release the Talk button and listen for a
response.
Both radios must be tuned to the same
channel/privacy code to communicate.
For charging microTALK
®
radio(s) in desktop charger:
1. Insert radio(s) into desktop charger as shown.
2. Insert the micro-USB cable into jack on back of charger.
3. Plug the cable into USB compatible power port.
For pluggable equipment, the socket-outlet shall be
installed near the equipment and shall be easily
accessible.
If charging light is not on, check position of radio. Radio should be
upright. The charge indicator light will stay on as long as the radio is in
the charging well, and the light will go off when the charging is complete.
Note: To charge a single radio, you can bypass the desktop charger and
simply insert the micro-USB’s connector directly into the charge jack
located on the left side of the radio.
The radio will display ashing battery icon while charging.
Cobra recommends your radio be turned off while being charged.
Both radios must be tuned to the same
channel and privacy code to communicate.
This radio is equipped with default Privacy Code on each
channel for minimizing unwanted signals from others. See page 6
to 8 for procedures changing your radio from default Privacy Code
to a different Privacy Code or disabling Privacy Code.