Specifications
6
Lighting the Pilot Burner
NOTE:
All Barbeque models incorporate the push button
piezo ignition system for each individual pilot
burner.
1. Depress the gas control knob and rotate anti-
clockwise to the ‘PILOT’ position.
2. With the gas control knob held in the depressed
position, depress the piezo igniter button located
on the front control panel to the right of the gas
control knob, until the pilot burner ignites. .
(Each depression operation of the piezo igniter
button will generate a single spark). Pilot ignition
can be viewed through openings in the plastic
surround fitted to the piezo igniter button.
3. Hold in the gas control knob for approximately
10-15 seconds, then release. The pilot burner
should remain alight. (If not repeat Items 2 and
3 above).
Lighting the Main Burner
1. Turn the gas controls anti-clockwise to first stop
(‘FULL’ flame position) and allow the griddle
plates to heat up to the operating temperature.
2. ‘LOW’ flame can be achieved by depressing
the gas control knob and rotating fully anti-
clockwise.
3. For intermediate heat, position the gas control
knob between the ‘HIGH’ and ‘LOW’ positions to
achieve the desired heat.
4. During idle periods, the main burners can be
turned down to maintain an appropriate plate
temperature or the gas controls can be set to
the ‘PILOT’ position as required.
NOTE:
Always set the gas control knob to the ‘HIGH’
position when lighting the main burners.
If the pilot burner goes out during normal
operation, wait 5 minutes before attempting to
re-light the pilot burner.
Part 4 Operation
Operation Guide
1. The Cobra Barbeques have been designed to
provide simplicity of operation and 100% safety
protection.
2. Improper operation is therefore almost
impossible, however bad operation practices
can reduce the life of the barbeque and
produce a poor quality product. To use this
barbeque correctly please carefully read the
following sections.
Lighting the Pilot Burner.
Lighting the Main Burner.
Description of Controls
C
AUTION
:
This appliance is for professional use and
is only to be used by qualified people.
Only qualified service persons should be
used to carry out installation, servicing or
gas conversion operations.
Components having adjustments
protected (e.g. paint sealed) by the
manufacturer should not be adjusted by
the user/operator.
Piezo Igniter
Gas Control Knob
๐ OFF Position.
Pilot Burner.
HIGH Flame.
LOW Flame.
Should any abnormal operation like;
- ignition problems,
- abnormal burner flame,
- burner control problems,
- partial or full loss of burner flame in normal
operation,
be noticed, the appliance requires IMMEDIATE
service by a qualified service person and shall not
be used until such service is carried out.
IMPORTANT