Specifications

Part 6 Gas Conversion

3. Determine the correct injector size for the

corresponding gas from the table shown in the

'Gas Specifications' section on page 3.

4. Fit the new pilot injector into the rear of the pilot

burner and push fully home.

5. Re-connect the gas supply tube to the base of

the pilot burner and tighten.

Low Fire Adjustment (All Models)

1. To set the burner low fire adjustment, the low fire

adjustment screw on the gas control valve

should be screwed fully in, then un-screwed by

the measurement shown in the 'Gas

Specifications' table.

NOTE:

The “Low Fire Adjustment Screw” should be sealed

with coloured paint on completion of the low fire

adjustment.

2. Refit the front control panel to the barbeque

and secure in position by tightening the 2 screws

on the front lower edges of the control panel.

3. Refit the gas control knobs to the gas control

valves. The gas control knobs are a push fit onto

the shaft of the gas control valves.

Piezo Igniter

Pilot Burner

Thermocouple

NOTE, Pin rotated

for Natural Gas

NOTE, Pin rotated

Gas Regulator

NOTE:

The regulator supplied is convertible between

Natural Gas and LPG, but it’s outlet pressure is fixed

ex-factory and is NOT to be adjusted.

1. Ensure that the gas supply is turned ‘OFF’ at the

mains.

2. Unscrew the hexagonal cap (23mm A/F) from

the regulator.

3. Un-clip the plastic pin from the cap, rotate the

pin and re-fit it back into the cap the correct

way for the gas type to be used. (Either ‘LP’ or

‘NAT’ should be visible on the flank of the pin

once re-fitted to the cap).

4. Screw the cap back into the regulator.

Low Fire

Adjustment Screw