Specifications
9
Part 6 Gas Conversion
Gas Conversion Procedure
NOTE:
These conversions should only be carried out
by qualified persons. All connections must be
checked for leaks before re-commissioning the
appliance.
Adjustment of components that have
adjustments/settings sealed (e.g. paint
sealed) can only be adjusted in accordance
with the following instructions and shall be re-
sealed before re-commissioning this
appliance.
For all relevant gas specifications refer to the
table at the end of this section.
Main Burners
1. Ensure that the gas supply has been turned 'Off'.
2. Remove the gas control knobs from the front
control panel. The control knobs are a push fit
onto the shaft of the gas control valves.
3. Remove the front control panel by slackening
the 2 screws on the front lower edges of the
control panel and remove the panel from the
front of the barbeque.
4. Remove the barbeque castings and inner
radiants to reveal the burners.
5. Carefully push the main burners forward and
carefully negotiate between the shield brackets
fitted over the end of the burners and remove
the burners from the barbeque to reveal the
main burner injectors.
6. Unscrew the main burner injectors from the
barbeque using a 13mm /
1
/
2
" A/F spanner.
7. Determine the correct injector sizes for the
corresponding gas, from the table shown in the
'Gas Specifications' section.
8. Replace with the correct size injectors.
9. Refit the main burner castings and inner radiants
to the barbeque.
Pilot Burners
1. To remove the pilot burner, disconnect the gas
supply tube from the base of the pilot burner.
2. Using a small screwdriver,withdraw the injector
from inside the pilot burner.
C
AUTION
:
Ensure that the Unit is isolated from the gas
supply before commencing servicing.
Main Burner
Shell
Brackets
Unscrew here with
13mm Spanner
Main Burner
Injector
Unscrew Gas
Supply Tube Here
Thermocouple/
Pilot Burner/Igniter
Retaining Plate
Screw Secured
Piezo HT Lead
Gas Supply Tube