Owner's Manual

ManualsBrandsCobra ManualsGPS & car accessoriesCA-MICROUSB-003

~,cobra®

HARDWIRE

KIT

INSTALLATION

GUIDE

WARNING:

Cobra

not

responsible

for

damages

the

vehicle

any

connected

products

accessories.

Working

with

your

vehicle's

power

system

can

dangerous

both

you

and

your

vehicle.

Cobra

recommends

professional

automotive

installation

avoid

damage

This

Vehicle

Hardwire

Kit

connects

your

Micro

USB

powered

device

directly

your

fuse

box,

freeing

your

12V

accessory

port

and

eliminating

clutter

your

dash

board.

This

Hardwire

Kit

should

work

with

any

Micro

USB

powered

device,

but

designed

and

tested

specifically

for

Micro

USB

powered

Radar

Detectors

and

Dash

Cams

from

Cobra.

Note:

Fuse

box

locations,

fuse

types,

and

interior

designs

vary

greatly

vehicle.

This

guide

intended

outline

basic

steps

for

installation

but

the

process

may

differ

depending

your

car's

make

and

model.

Installation

Instructions:

Position

your

device

its

desired

location

the

windshield,

ensuring

that

does

not

obstruct

your

view

the

road

ahead.

Consult

your

vehicle's

manual

locate

your

fuse

panel.

Run

the

hardwire

kit

from

your

device,

and

around

the

windshield,

and

your

fuse

box.

Generally

you'll

want

position

the

hardwire

kit

that

excess

cable

can

coiled

near

the

fuse

box

side.

Note:

The

Converter

Box

not

designed

withstand

the

harsh

environment

under

the

hood

your

vehicle

and

should

not

installed

there.

You

need

decide

whether

you

want

your

device

wired

switched

un-switched

fuse

Switched

circuits

only

have

power

when

the

vehicle

ON.

Un-switched

circuits

always

have

power.

bra

Ele

ics

Ver

ion

Prin

China 1

Summary of content (4 pages)

PAGE 1
~,cobra® HARDWIRE KIT INSTALLATION GUIDE WARNING: Cobra is not responsible for damages to the vehicle or any connected products or accessories. Working with your vehicle's power system can be dangerous to both you and your vehicle. Cobra recommends professional automotive installation to avoid damage. This Vehicle Hardwire Kit connects your Micro USB powered . device directly to your fuse box, freeing up your 12V accessory port and eliminating clutter on your dash board.
PAGE 2
DIRECT WRAPPING 1. Make sure your vehicle is off and the key is not in the ignition. Choose your desired fuse. You can verify if it is switched or unswitched using a voltmeter. Pull the fuse, wrap exposed copper part of the red (+) wire around the fuse tooth, and re-insert the fuse. 2. Locate a ground point near the fuse box. There is usually either an obviously labeled ground point or a nut/bolt that connects directly into the car frame. 3.
PAGE 3
FCC STATEMENT: This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation. WARNING: Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.
PAGE 4
DISPOSAL OF ELECTRONICS EQUIPMENT: This product may contain hazardous substances that could impact health and the environment if not disposed of properly. .---...... The crossed out wheeled bin symbol indicates that the product should ~ not be disposed of along with household waste. It should be handed over to an applicable collection point for the recycling of electrical ._•_•-•___. equipment.