Specifications

17
Part 6 Gas Conversion
Gas Specifications
- Australia
- New Zealand
NOTE:
(*) Measure burner operating pressure at manifold test point with two burners operating at the ‘High’
setting. Operating pressure is ex-factory set through appliance regulator and is not to be adjusted,
apart from when carrying out gas conversion. (Refer to ‘Gas Conversion’ section for details).
Natural Gas
LP Gas
(Propane)
Burner Injector
Ø 2.10mm Ø 1.30mm
Low Fire Setting
¾ turn open c.c.w.
¼ turn open c.c.w.
Burner Aeration Setting
16 mm open. 16mm open.
Griddle
Burner Injector
Ø 2.00mm Ø 1.25mm
Pilot Injector
0.35 0.23
Supply Pressure
1.13 - 3.40 kPa 2.75 - 4.50 kPa
Burner Operating Pressure (*)
1.0 kPa 2.6 kPa
Gas Regulator Cap Screw
Open Burner
Burner Aeration Setting
Fully open. Fully open.
Low Fire Setting
5
/
8
turn open c.c.w.
3
/
8
turn open c.c.w.
Natural Gas LP Gas
Burner Injector
Ø 2.10mm Ø 1.30mm
Low Fire Setting
¾ turn open c.c.w.
¼ turn open c.c.w.
Burner Aeration Setting
16 mm open. 16mm open.
Griddle
Burner Injector
Ø 2.00mm Ø 1.25mm
Pilot Injector
0.35 0.23
Supply Pressure
1.13 - 3.40 kPa 2.75 - 4.50 kPa
Burner Operating Pressure (*)
1.0 kPa 2.6 kPa
Gas Regulator Cap Screw
Open Burner
Burner Aeration Setting
Fully open. Fully open.
Low Fire Setting
5
/
8
turn open c.c.w.
3
/
8
turn open c.c.w.