Specifications

16
Part 6 Gas Conversion
Gas Type Identification Label
On completion of gas conversion, replace gas type
identification label located at:-
- Rear of appliance, above gas connection
point.
- Beside the rating plate.
Commissioning
Before leaving the converted installation;
1. Check all gas connections for leakages using
soapy water or other gas detecting equipment.
2. Check the following functions in accordance
with operating instructions specified in the
'Operation' section of this manual.
 Light Main Burners.
 Check Low Fire burner operation.
 Check High Fire burner operation.
 Check Griddle Burner operation (If fitted).
 Ensure that all controls operate correctly.
 Ensure that operating pressure remains
correct.
3. Ensure any adjustments done to components
that have adjustments / settings sealed (e.g.
paint sealed), these are re-sealed.
NOTE:
If it is not possible to get the appliance to operate
correctly, shut ‘Off’ the gas supply and contact the
supplier of this appliance.
WARNING:
D
O NOT USE A NAKED FLAME TO CHECK FOR GAS LEAKAGES.