Operation Manual

Assembly Instructions
• The suction/blowing pipes must be assembled
before the machine is used. (Fig.1)
• Fit guiding grooves on the lower section of
suction/blowing pipes into
upper section.
• Push two sections firmly together until the clip in
the moulding engages.
• Fasten bolt and nut to place A where the suction/
blowing pipe cannot reach. The M6x35 bolt and
nut are enclosed in the accessories (Fig. 2).
• Slide the suction/blowing pipe into motor housing
• Secure screws on both sides of position A and B.
The screws are enclosed in the accessories.
(Two ST5x16 screws for position B, two ST4x16
screws for position A) Make sure the
suction/blowing pipes are firmly closed with
the housing (Fig. 3).
• Attach the vacuum bag to the hook on the
suction/ blowing pipes (Fig. 4).
9