Electric Blower Vac BV2600 WARNING! Read all safety warnings and all instructions. Failure to follow the warnings and instructions may result in electric shock, fire and/or serious injury. Keep this manual safe.
.............................................................................................. ....................................................................................... ........................................................................................ .......................................................................... .................................................................................. ........................................... ......................................
230V/50Hz 2400 W 11000-15000/min 2
1 x Unit 1 x Blower tube 1 x Waste collection bag 1 x Instruction manual 3
General Safety Instructions WARNING! Read all instructions. Failure to follow all instructions listed below may result in electric shock, fire and/or serious injury. The term "power tool" in all of the warnings listed below refers to your mains operated (corded) power tool or battery operated (cordless) power tool. SAVE THESE INSTRUCTIONS Work Area: • Keep work area clean and well lit. Cluttered and dark areas invite accidents.
General Safety Instructions (Cont.) Personal Safety: • Stay alert, watch what you are doing and use common sense when operating a power tool. Do not use a power tool while you are tired or under the influence of drugs, alcohol or medication. A moment of inattention while operating power tools may result in serious personal injury. • Use safety equipment. Always wear eye protection.
General Safety Instructions (Cont.) Power Tool Use and Care (Cont.): • Maintain power tools. Check for misalignment or sticking of moving parts, breakage of parts and any other condition that may affect the power tool's operation. If damaged, have the power tool repaired before use. Many accidents are caused by poorly maintained power tools. • Keep cutting tools sharp and clean. Properly maintained cutting tools with sharp cutting edges are less Iikely to stick and are easier to control.
Additional Safety Instructions for Electric Garden Blower Vac • Always wear adequate protective clothing when operating the tool to avoid injuries to face, eyes, hands, feet, head or hearing. Use safety glasses or a face shield, high boots or sturdy shoes, long trousers, work gloves, a hard hat and ear defenders. • Do not start the tool when it is upside down or when it is not in the operating position.
Additional Safety Instructions for Electric Garden Blower Vac (Cont.) • Do not attempt to pick up breakable objects like glass, plastics, china, etc. • Do not use in vacuum operation without the waste collection bag fitted. • Do not use the blower vac in either the vacuum or the blow position on gravel surfaces.
Assembly Instructions • • • • • The suction/blowing pipes must be assembled before the machine is used. (Fig.1) Fit guiding grooves on the lower section of suction/blowing pipes into upper section. Push two sections firmly together until the clip in the moulding engages. Fasten bolt and nut to place A where the suction/ blowing pipe cannot reach. The M6x35 bolt and nut are enclosed in the accessories (Fig. 2).
Assembly Instructions (Cont.) • Insert the clip joint of the collection bag into the ejection pipe at the motor housing. (Fig. 5) Operation Before starting the machine, make sure that the debris collection bag (9) is correctly fitted and the shoulder strap (12) is adjusted to a suitable working position. Ensure the blower tubes are properly secured prior to operation. Turning On and Off: • To Switch On: Push the On/Off Switch (2) to the ‘1’ on position.
Operation (Cont.) Mode Selection: Next to the mode selection knob are icons that indicate the blowing and vacuum settings. • Blowing Mode: Rotate the mode selection knob (10) so that the arrow of the knob points to the "blowing" icon (Fig.1). Ensure that when the knob is rotated it clicks into place. • Vacuum Mode: Rotate the mode selection knob (10) so that the arrow of the knob points to the "vacuuming" icon (Fig.2). Ensure that when the knob is rotated it clicks into place.
Operation (Cont.) Vacuum Mode (Cont.): When the collection bag is full, the vacuum power will be greatly reduced. When this happens, turn the switch to the position "0" (off): • Turn the switch to the position "0" (off) • Disconnect the plug from the power supply • Open the zip fastener of the collection bag. Spread out the opening and empty the bag of its contents. If you have collected only leaves or vegetable matter, they will already have been shredded and will be ready for composting.
Maintenance • Place switch in "0" off position and unplug from the power supply before the blower vac is serviced, cleaned or maintenance is performed. • Keep air intake clean and air vents free of debris to avoid overheating the motor. • Do not use cleaning agents to clean the plastic parts of the tool. A mild detergent on a damp cloth is recommended. Water must never come into contact with the tool. • If the blower vac vibrates abnormally, stop motor immediately.
Guarantee Policy Thank you for choosing a Cobra Blower Vac. In order to get maximum benefit from your new purchase, please be aware of the warranty provisions outlined in this document. Your Electric Blower Vacuum is guaranteed for a period of 12 months from the original date of purchase. As the product is intended exclusively for home consumer use, thus use of this product for professional, industrial or high frequency use will VOID this warranty.
Please retain your Proof of Purchase. Only the original owner is covered by the manufacturer’s warranty and must have purchased the product from an authorised Cobra dealer. What is not covered under warranty? • Professional, Industrial or high frequency use if the purpose of the tool is stated as consumer use in the instruction manual. • If the tool has been operated on a supply voltage other than that specified on the tool.
9.Declaration of Conformity We, the undersigned, Cobra Garden, Henton and Chattell Ltd., London Road, Nottingham NG2 3HW UK Declare that The following devices are appropriate and consistent with the basic safety Health and EC directives (see point 3), based on their design and type, as circulated by us. This declaration relates exclusively to the machinery in the state in which they were placed on the market and excludes added and / or components operations carried out subsequently by the end user. 1.
