Manualshelf

Installation manual

ManualsBrandsCobra ManualsAutomotiveBridge 4100
21222324252627282930
VEHICLESECURITY
FITTING INSTRUCTIONFITTING INSTRUCTION
FITTING INSTRUCTIONFITTING INSTRUCTION
FITTING INSTRUCTION BRIDGE 4100
23
How to regulate the buzzer volumeHow to regulate the buzzer volume
How to regulate the buzzer volumeHow to regulate the buzzer volume
How to regulate the buzzer volume
Access the programming mode to regulate the volume of the buzzer. The system must be
disarmed, the door and bonnet must be open and the dashboard must be on (+15 activated).
Keep key “A” on the radio control depressed. If all the conditions are favourable, the LED on the
emergency override panel will come on and the system will respond after about 3 s by flashing
the turn indicators to inform you that you have accessed the buzzer table of the programming
function. Press key “A” on the radio control to increase the volume of the buzzer, or press key
“B” to lower it.
Shut the bonnet to quit the programming function.
How to program the systemHow to program the system
How to program the systemHow to program the system
How to program the system
To access the programming mode, the system must be disarmed, the door and bonnet must be
open and the dashboard must be on (+15 activated). Keep key “A” on the radio control depressed.
If all the conditions are favourable, the LED on the emergency panel will come on and the
system will respond after about 3 s by flashing the turn indicators to inform you that you have
accessed the buzzer table of the programming function. Press key “A” on the radio control to
increase the volume of the buzzer, or press key “B” to lower it.
To switch to the next table, turn the ignition key OFF and then ON again. The system will respond
with two flashes from the turn indicators to inform you that you have accessed table 2.
This signal will be given every 10 s or so to remind you the number of the page you have
accessed.
To switch to table 3, turn the ignition key OFF and then ON again. The system always confirms
that the table has changed by flashing the blinker three times.
Four flashes mean that you are in table 4.
How to activate/deactivate a functionHow to activate/deactivate a function
How to activate/deactivate a functionHow to activate/deactivate a function
How to activate/deactivate a function
After having accessed one of the tables, press key “A” on the radio control and go to the number
of the line corresponding to the function you wish to activate/deactivate. A fast flash will indicate
that the function is deactivated. A slow flash indicates that it is activated. The number of flashes
correspond to the number of the line in the function table you have selected.
Press key “B” on the radio control to activate/deactivate a function.
Several functions can be activated in the same page at the same time. Activation of a function
does not deactivate the others.
When you shut the bonnet, the system will flash the turn indicators for 3 s to inform you that you
have quit the programming procedure.
Refer to page 25 which contains a quick programming guide.
VEHICLESECURITY
MANUEL D’INSTALLATION MANUEL D’INSTALLATION
MANUEL D’INSTALLATION MANUEL D’INSTALLATION
MANUEL D’INSTALLATION BRIDGE 4100
42
b
A
A
O
N
ON
OFF
OFF
IGN +15
ALARME
DÉSACTIVÉE
POUR ENTRER EN MODE PROGRAMMATION
A
D
OK
POUR CHANGER DE TABLEAU
O
N
ON
OFF
OFF
POUR CHANGER DE LIGNE
POUR QUITTER
POUR ACTIVER / DÉSACTIVER UNE FONCTION
F
C
B
3"
E
06DE2143A installatore Segn.pmd 20/10/2005, 12.1523