Installation manual

VEHICLESECURITY
FITTING INSTRUCTIONFITTING INSTRUCTION
FITTING INSTRUCTIONFITTING INSTRUCTION
FITTING INSTRUCTION BRIDGE 4100
21
POSITIONING THE COMPONENTS OF THE SYSTEMPOSITIONING THE COMPONENTS OF THE SYSTEM
POSITIONING THE COMPONENTS OF THE SYSTEMPOSITIONING THE COMPONENTS OF THE SYSTEM
POSITIONING THE COMPONENTS OF THE SYSTEM
All the parts of the system should be installed in hidden locations which are difficult to access
and are wail away from heat sources.
Alarm unitAlarm unit
Alarm unitAlarm unit
Alarm unit
Fit in the passenger compartment using the double-side adesive material provided. The alarm
unit main connector should exit downwards.
Siren with back up batterySiren with back up battery
Siren with back up batterySiren with back up battery
Siren with back up battery
Locate in the engine bay taking care to position it as indicated.
Siren without back up batterySiren without back up battery
Siren without back up batterySiren without back up battery
Siren without back up battery
Fix in the engine compartment, using the screws
provided, to a metal surface to facilitate heat
dissipation.
Bonnet switchBonnet switch
Bonnet switchBonnet switch
Bonnet switch
The button must be installed to allow access to the alarm programming procedures and radio
control auto-learning phase.
After installation, check to make sure that the button is depressed at least 5 mm by the bonnet.
Make sure that the button does not press against soundproofing panels or against the outer
bodywork of the vehicle as these materials could deform over a period of time.
NO
O.K.
1
2
3
4
Ø 3 mm.
VEHICLESECURITY
MANUEL D’INSTALLATION MANUEL D’INSTALLATION
MANUEL D’INSTALLATION MANUEL D’INSTALLATION
MANUEL D’INSTALLATION BRIDGE 4100
44
PAGE 5
PAGE 4
PAGE 3
1 ACTIVATION PASSIVE DE LALARME
2 ACTIVATION PASSIVE DU BLOCAGE MOTEUR DEPUIS LA CLÉ
3 ALARME DEPUIS +15 PAR ACTIVATION PASSIVE
4 RÉARMEMENT AUTOMATIQUE DISPOSITIF
5 RÉARMEMENT AUTOMATIQUE SYSTEME DALARME
6 FERMETURE PORTES PAR RÉARMEMENT AUTOMATIQUE SYSTEME
7 SIGNALISATION PORTES OUVERTES A LACTIVATION
8. SIGNALISATION CLIGNOTANTS PENDANT LES PHASES DACTIVATIO
N ET DÉSACTIVATION
PROGRAMMATION USINE
1 ACTIVATION BUZZER PENDANT LES PHASES DACTIVATION/DÉSACTIVATION
4 ACTIVATION ANTI-AGRESSION MANUELLE
6 ACTIVATION FONCTION AUTOHAZARD
7 ACTIVATION FONCTION DE SIGNALISATION EXCèS DE VITESSE
8
NE PAS UTILISER
2 BUZZER POUR LA FONCTION CAR FINDER
3 ACTIVATION ANTI-AGRESSION AUTOMATIQUE
5 NE PAS UTILISER
1 ACTIVATION PAGER TEMPORISÉ * / FIXE **
2 ACTIVATION DE LA FONCTION
3
NE PAS UTILISER
4
NE PAS UTILISER
5
NE PAS UTILISER
6 ACTIVATION RETARD DE COMMANDE VITRES
7
NE PAS UTILISER
8 ACTIVATION FONCTION SORTIE VITRES
TABLEAU DES FONCTIONS DE BASE
TABLEAU DES FONCTIONS AVANCÉES
Clignotement long
Clignotement court
ACTIVÉE DÉSACTIVÉE
ACTIVÉE DÉSACTIVÉE
ACTIVÉE DÉSACTIVÉE
ACTIVÉE DÉSACTIVÉE
ACTIVÉE DÉSACTIVÉE
ACTIVÉE DÉSACTIVÉE
ACTIVÉE DÉSACTIVÉE
ACTIVÉE DÉSACTIVÉE
ACTIVÉE DÉSACTIVÉE
ACTIVÉE DÉSACTIVÉE
ACTIVÉE DÉSACTIVÉE
ACTIVÉE DÉSACTIVÉE
ACTIVÉE DÉSACTIVÉE
ACTIVÉE DÉSACTIVÉE
ACTIVÉE DÉSACTIVÉE
ACTIVÉE DÉSACTIVÉE
ACTIVÉE DÉSACTIVÉE
ACTIVÉE DÉSACTIVÉE
ACTIVÉE DÉSACTIVÉE
ACTIVÉE DÉSACTIVÉE
ACTIVÉE DÉSACTIVÉE
ACTIVÉE DÉSACTIVÉE
ACTIVÉE DÉSACTIVÉE
ACTIVÉE DÉSACTIVÉE
* TEMPORSÉÊ: Ligne 1 activée (COMMANDE PAGER = DURÉE ALARME 30)
** FIXEÊ: Ligne 1 désactivée (COMMANDE PAGER ACTIVE JUSQU'A SA DÉSACTIVATION)
06DE2143A installatore Segn.pmd 20/10/2005, 12.1521