Specifications

Operation
Operation
37
S/RF Meter
This meter swings proportionately to the RF
output (outgoing signal) while transmitting.
External Speaker
The external speaker jack is used for remote receiver
monitoring.
The S/RF-SWR/CAL button must be in the
S/RF mode.
1
Note
The external speaker should
have 8-ohm impedance and
be rated to handle at least 4.0
watts. When an external speaker
is plugged in, the internal speaker
is automatically disconnected.
Note
Cobra external speakers are
rated at 10 watts.
Connect an external speaker to the external speaker
jack on the rear panel.
36
To achieve the Desired Squelch Setting (DSS),
rotate the Squelch knob counterclockwise until you
hear noise. Now rotate the knob clockwise just until
the noise stops. This is the DSS setting.
3
NOISE
WEAK SIGNALS
MEDIUM SIGNALS
STRONG SIGNALS
GATE
Gate set to Desired
Squelch Setting (DSS)
Continued
ANT
EXT MIC EXT. PTT EXT.SP.
+POWER–
SIG
RF
+30dB
1
1.5
2
3
CAL
3
5
7
9
SWR
TX
RX
NB/ANL
MEM WX !
ANL
S/RF
NB/ANL
S/RF
SWR/CAL
ESC
MEM SCAN
SCAN CH 9/19
DIM
CB/WX
M
E
N
U
P
U
S
H
E
N
T
E
R
VOL
DYNAMIKE
RF GAIN
DELTA TUNE
T BACK
SWR
CAL
OFF MIN
MIN OFF
MAX
SQ
SIG
RF
+30dB
1
1.5
2
3
CAL
3
5
7
9
SWR
RX
NB/ANL
MEM WX !
ANL
S/RF
NB/ANL
S/RF
SWR/CAL
ESC
MEM SCAN
SCAN CH 9/19
DIM
CB/WX