Owner's Manual
Table Of Contents
- Operating Instructions
- The CB Story
- Controls and Indicators
- Our Thanks to You
- Contents
- Installation
- Antennas
- Ignition Noise Interference
- Operation
- Setting Dynamike®
- Setting the Alarm
- Key Tones Mode On and Off
- Radio Check Mode
- Turn NightWatch Illumination On-Off-Hi-Lo
- Setting Contrast Mode
- Bluetooth®
- iRadar Smartphone App
- Rewind-Say-Again®
- Weather Information
- Program Memory Channels
- Home And Office Set-Up
- Temporary Mobile Set-Up
- How Your CB Can Serve You
- Frequency Ranges
- 29 LX MAX Specifications
- Warranty
- FCC Statement
- Optional Accessories
- Product Info
Temporary Mobile Set-Up
Home And Office Set-Up
3938
Temporary Mobile Operation
For temporary mobile operation you may want to
purchase an optional cigarette lighter adapter from
your COBRA dealer. This adapter and a magnetic
mount antenna allow you to quickly “install” your
transceiver for temporary use.
ANT
EXT MIC EXT. PTT EXT.SP.
+POWER–
Base Station Operation
To operate your transceiver from home or office
you will need a 13.2 volt DC Power Pack rated at a
minimum of 2 amps, and a properly installed base
station antenna.
Warning!
Do not attempt to operate this
transceiver by connecting it directly
to 120V AC.
Note
For further information call Cobra
Customer Service 1.773.889.3087.
1
Connect the properly installed and matched base
station antenna.
Simply connect the red (+) and black (-)
leads of the transceiver to the corresponding
terminals of the power pack.
Plug the power cable into the back of the unit
marked “Power”. Be sure to observe the polarity
markings.
2
3
ANT
EXT MIC EXT. PTT EXT.SP.
+POWER–
+—
29LX_MAX_MANL.indd 38-39 10/27/16 4:03 PM