Specifications

Rotate the On/Off Volume knob clockwise.
The green RX/TX LED will be illuminated.
Repeat the same steps 2 to 5 on Channel 1
and 40.This will check SWR for all channels.
The S/RF switch must be in the S/RF position
to read the meter.
6
While still holding down the microphone
button,set the S/RF-SWR-CAL switch to the
SWR position,to read the SWR reading.
5
Operation
13
Operation
12
1
Note
With the S/RF-SWR-CALswitch
in the SWR position the meter
needle should ideally be as far
to the left as possible.
Anything over 3 is not accept-
able. A slight antenna height
adjustment (higher or lower)
may be required. Repeat
relcalibration steps.
S-Meter
S-Meter
Swings proportionately to strength of incoming
signal when receiving.
Switch to NOR to select desired channel.
1
Selecting A
Channel
Selecting A Channel
Note
Switch to 9 or 19 for instant
access to these channels.
To Receive
1
To Receive
29 UK-English.qx 6/22/99 12:14 PM Page 12