User Manual

9
8
English
Installation
Customer
Assistance
Main Icons
Intro Operation Customer
Assistance
Warranty
Notice
Secondary Icons
Caution Warning
Installation
Customer
Assistance
Operating Your CB Radio
Operation
Intro Operation Customer
Assistance
Warranty
Notice
Secondary Icons
Caution Warning
Installation
Customer
Assistance
Operating Your CB Radio
Signal Strength Meter
The Signal Strength Meter indicates the received signal strength
from the antenna. The meter segments shown on the LCD increase
with signal strength.
TX Indicator
The TX Indicator appears when in transmit mode. In this mode,
the meter shows all bars at full output power.
Channel Frequency
Displays the current channel and receive transmit frequency.
Enable/Disable VOX
1. Push and hold the Push-To-Talk switch on the microphone, then
2. Push and release the MENU button.
3. This will both enable/disable the VOX function.
S/RF Power Meter
TX Indicator
Main Icons
Channel Frequency
Channel Selection
Intro Operation
1. Push and release the Channel knob.
2. Rotate the channel knob left or right to select the channel.
3. Push and release the channel knob to save the setting.
Selecting a Channel
LCD Display Function Setting
KEY BP Beep on (default): turn on beep
oF: turn off beep
ROG BP
Roger Beep Sound Setting oF, Tone settings 01 - 06
(Tones) oF: (default) turn off
roger beep
VOX L
VOX Sensitivity Level Setting Level: 01 - 09
Default: 03
VOX T VOX Delay Time Setting Level: 01 - 09
Default: 01
RF.GAIN RF Gain Control Levels
: 03, 06, 09 - 48
oF (default) RF gain off
TOTSET Time Out Timer oF, 01 - 10 minutes
Default: 05
PWRAUTO
Automatic Power On Setting on (default): Auto power on
oF: Manual power on
FW VER Firmware Version Displays 2-digit
Firmware Version
RESET See Reset to Factory
Default Section
Menu Options
1. Push and release the MENU button to access menu options
(see menu options in the Table below).
2. Rotate knob to select Menu Option
3. Push and release knob on selected option, then
rotate knob to desired setting and push knob again
to save setting
Selecting the Menu
Selecting the Menu
Intro Operation
Operation
VOX