User Manual

7
6
English
y Icons
Installation
Main Icons
Operating Your CB Radio
OperationOperation
Intro Operation Customer
Assistance
Warranty
Notice
Secondary Icons
Caution Warning
Installation
Customer
Assistance
Operating Your CB Radio
Channel 9/Channel 19 Button
To auto squelch your radio:
1. Push and hold the SQ/ASQ button until "AQ" shows on the LCD
display. The ASQ level set will also show in the lower left side
of the display.
2. Rotate the Channel knob to set the desired squelch level.
3. Push and release the SQ/ASQ button to save the setting.
Adjust Squelch
Turning on Your CB Radio
Push and release the Vol/ON/OFF knob to power
ON the radio.
On-Off/Volume Knob
Notice
Volume
Rotate the channel knob left or right to adjust the volume.
On-Off/Volume Knob
Notice
Channel 9/Channel 19
Set CH 9 to obtain instant access to the emergency channel.Set CH 19
to obtain instant access to the information and calling channel.
Channel 9/19 access:
1. Push and release the Channel 9/19 button to quick select channel 9.
2. Push and release the Channel 9/19 button a second time to
select channel 19.
3. Push and release the Channel 9/19 button a third time to return to the
last used channel
To squelch your radio:
1. Push and release the SQ/ASQ button.
2. Rotate the Channel knob to set the desired squelch level.
3. Push and release the SQ/ASQ button to save the setting.
Adjust Squelch
Auto Squelch
The Auto Squelch (ASQ) feature can help to improve the receiver
performance experience when enabled for communicating with
nearby stations. For weaker or more distant stations consider using
the SQ (traditional squelch) system or disable squelch for continuous
receiver audio.
Operating Procedure to Receive
Be sure the power cord, antenna and microphone are connected to
the proper connectors before proceeding further (see pages 4 and 5).
To receive:
1. Turn ON the radio.
2. Select the desired channel.
3. Set squelch to OFF (audio noise heard from speaker).
4. Set the receiver volume to a comfortable listen level.
5. Reset the squelch level for the intended listening requirements.
On-Off/Volume Knob
Squelch/ASQ Button
Press-to-Talk Switch
Main Icons
Squelch
This control is used to cut off or eliminate receiver background noise in the
absence of an incoming signal when properly adjusted.
Operating Procedure to Transmit
Be sure the antenna is properly connected to the radio before
transmitting. Prolonged transmitting without an antenna, or with a
poorly matched antenna, could cause damage to the transmitter.
To transmit:
1. Select the desired channel.
2. The receiver and transmitter are controlled by
the Push-to-Talk switch on the microphone.
Press the switch and the transmitter is activated; release
switch to receive. When transmitting
(on a clear channel), hold the microphone
two inches from the mouth and speak clearly
in a normal voice.