Owner's Manual

4
English
Installation and Start-Up
Installation
Microphone Connector
Allows for convenient removal of the Microphone plug
when storage is required. The Microphone MUST be
connected to the unit at all times, when in use, for
proper operation.
External Speaker
The speaker jack on the rear panel is used for an External Speaker.
The external speaker should have 8-Ohm impedance and be rated
to handle at least 4.0 watts. When the external speaker is plugged
in, the internal speaker is automatically disconnected.
NOTE
Cobra external speakers are rated 15 watts.
Microphone Connector
External Speaker Jack
Installation
Power Cable
Installation
NOTE
Cobra offers a line of antennas for use with your 19 Series CB Radio.
Go to cobra.com/collections/cb-radio-accessories for antenna and antenna mounting options.
CB Antenna
Only a properly matched Antenna system will allow maximum power output. In mobile
installations (cars, trucks, boats, etc.), an antenna system that is nondirectional should be used.
When installed in a boat, the transceiver will not operate at maximum efficiency without a ground
plate unless the vessel has a steel hull. Before installing the transceiver in a boat, consult your
dealer for information regarding an adequate grounding system.
Power
These wires supply Power to the CB radio.
This cable is permanently attached to the radio.
If you wish to remove the radio after installation,
disconnect at fuse holder and ground connector.
Mounting and Connections continued
•