Specifications

12
9. Install the front wheel, and torque the axle to 13.5N-m (10 ft-lb).
10. Drop the bike onto the ground, engage the front brake, and push up and down
on the handlebars several time to ensure that the front forks and the front wheel
are properly aligned with each other.
11. Tighten the axle pinch bolts to 10N-m (7.4 ft-lb).
Ignition Timing
The ignition timing value for the CX65 is 5° retarded from the standard base
reference (0°). This can be verified by removing the ignition cover and looking as
shown in the figure below.
The center mark on the cases is the standard base reference timing mark (0°), and
the other two large marks are 5° advanced and retarded. The small timing marks
between 0 & 5° is 2.5°.
To change the timing, one must remove the flywheel with Cobra 65 flywheel puller #
MCMUTL05. After the flywheel has been removed, the timing can be adjusted by
loosening the stator bolts and rotating the stator to the desired position.