Specifications

10
4. Put a rag between the sprocket and
chain, and roll the wheel backward
to pull the chain adjustor blocks
tightly against the adjustor bolts
(Figure 3).
5. Retighten the axle bolt to 25 ft-lb (34
Nm).
6. Retighten the adjustor jam nuts.
CAUTION:
Always check rear brake adjustment
and free-play after adjusting the chain.
Air Filter Cleaning
Tools recommended for air filter maintenance:
• 5 mm hex key (Allen)
• Foam filter oil
Procedure
1. Removed seat with the 5mm hex key.
2. Unhook the air filter wire from its perch
3. Carefully remove the air filter and frame out
the top of the airbox making sure not to
dislodge any dirt into the intake tract.
4. Clean the filter in a nonflammable solvent to
remove the filter oil.
Do not clean the air filter with gasoline or other
highly volatile petroleum product. Diesel fuel, mineral spirits, or kerosene would be
preferred but caution should still be taken.
5. Clean the filter in hot soapy water to remove
all dirt particles.
6. Allow it to dry thoroughly.
7. Saturate with filter oil and remove excess.
NOTE: It is very important to keep the air filter
clean and properly oiled with high quality water-
resistant foam filter oil. Apply oil consistently
because varied amounts of oil will affect
carburetor jetting.
8. Reinstall the filter assembly by pushing it
down and forward into the airbox making
sure the lip of the filter cage is properly
Figure 5
Figure 4
Figure 3