Use and Care Manual

9 | P a g e
RADAR ALERT SETTINGS
The detector allows you to choose whether it will show alerts on the X, K and Ka Bands. The
factory settings are: X, K, and Ka On.
To Turn X Band On and Off
While no signal is being detected, press and hold both the DIM and MUTE buttons for four
seconds.
X Off = One beep and X flashes once
X On = Two beeps and X flashes twice
To Turn K Band On and Off
While no signal is being detected, press and hold both the SEN and MUTE buttons for four
seconds.
K Off = One beep and K flashes once
K On = Two beeps and K flashes twice
To Turn Ka Band On and Off
While no signal is being detected, press and hold both the SEN and DIM buttons for four
seconds.
Ka Off = One beep and Ka flashes once
Ka On = Two beeps and Ka flashes twice
DETECTION
The following tables show you the types of signals your detector will detect, and the visual
alerts for each.
AUDIO ALERTS
A distinctly different Alert tone is used for each type of signal detected (including separate
tones for each laser signal). For X, K and Ka band radar signals, the tones will repeat faster as
you approach the signal source. The repeat rate of the tones gives you useful information about
the signal detected.