Use and Care Manual

7 | P a g e
4. Attach the detector to the hook-and-loop fastener. You can remove and reattach the
unit as often as you like.
5. Plug the power cord into the detector.
6. Plug the cigarette lighter adapter on the power cord into your vehicle’s cigarette lighter.
BASIC OPERATION
POWERING ON THE DEVICE, ADJUSTING VOLUME
To turn on the unit and adjust the audio volume, rotate the On-Off/ Volume control clockwise
(away from you).
NOTE: In some vehicles, power is supplied to the cigarette lighter even while the ignition is Off.
If this is the case with your vehicle, you should turn Off or unplug your detector when parking
for lengthy periods.
SENSITIVITY MODES
Setting your detector to City mode sensitivity delays all X band audio alerts at lower signal
strength levels. (A single beep will sound when the signal is first detected.) This will reduce false
alerts while you are driving in, or near, urban areas where there are many sources for
conflicting X band signals such as microwave towers and automatic door openers. The factory
setting is Highway mode.
To change the sensitivity mode, press the SEN button.