How to Guide

15 | Page
Marker Enables
In the factory default setting, the suggested fixed location alerts are reported. It is highly
recommended that you use your RedLine 360c in this mode.
If you modify Marker Enables then this setting will show Modified and only the Markers that
you have selected are reported.
Marking Locations
The MRK button allows you to mark a specific location and label it for future reference. Once
marked, RedLine 360c will provide an alert when you reach this area again.
RedLine 360c gives advanced warning of upcoming markers at the following distances:
Red light cameras - 250 ft or 10 seconds
Red light & speed cameras - 250 ft or 10 seconds
Speed cameras - 500 ft when traveling below 55 mph
1,000 ft when traveling above 55 mph
Speed traps - 0.3 mi or approximately 1,584 ft
Other - 500 ft when traveling below 55 mph
1,000 ft when traveling above 55 mph
To Mark A Location
- Press MRK. The display will read “Mark?” Press MRK again to bring up a menu of
markers to choose from.
- Repeatedly press MUTE to scroll through the markers then press MRK to select the
marker that you wish to use at this location.
- The display will read “Marked!”
Air Patrol locations cannot be marked by the user.
Note: When a location is marked the first time, you must travel at least 1 mile away from
that location to receive an alert when you return to the area.