User's Manual

4
English
Installation Overview
Mount Unit
Main Detector Unit (MDU)
Note: To power the MDU, use one of the two power cords provided
(See Page A3).
• 12-Foot Power Cord – Acessory Plug: For connecton to 12-volt
vehicle accessory outlet, or
• 12-Foot Power Cord – Fuse Box: For connection to vehicle’s fuse
box using the in-line fuse and wires.
Fuse box hard wiring is recommended. Use this configuration to
provide a more discreet installation. If you are unsure about making
this connection yourself, contact a professional installer.
On a negative grounded vehicle:
1. Connect the positive wire [marked with a tag (+)] of the DC power cord
to an accessory 12-volt fuse that is controlled by the ignition switch
(Figure A).
2. Connect negitive wire (-) to a chassis ground location (Figure A). Body
paint may may need to be removed to assure a good ground
connection.
Introduction
ACC
Figure A
XRS_R7_R9G_1-5-07.qxd:Layout 1 1/9/07 5:14 PM Page 4
FOURTH DRAFT