User's Manual

Nothing Comes Close to a Cobra

Settings

Your Detector

Setting IntelliMute

From the IntelliMute Setup screen:

1. Press MUTE/

 button to start setup.

2. Press and hold the vehicle accelerator at desired engine RPMs.

3. Press DIM/

button to complete setting process.

System stores engine RPM setting and displays a completion message and a

tone or voice message. Unit must sense a usable pulse within three seconds

or a set RPM point within 30 seconds of beginning of setup, or IntelliMute

detects an error and turns off.

Change a set activation point by accessing Set IntelliMute in User Settings

Programming. Repeat three-step setup process above.

Auto Mute Mode

Auto Mute reduces audio volume of all alerts after four seconds. Alerts

remain muted as long as signal is detected. Alerts sound at full volume as

long as signal is detected when Auto Mute is off. Auto Mute factory setting is

on. Press the MUTE/

 from the Auto Mute screen to change the setting.

Voice or Tone Mode

Set detector to sound alerts and confirm program settings with a Voice or a

Tone. Voice Alert provides voice messages in addition to tones. Tone Alert

provides tones only. Factory setting is Voice Alert.

Remote Display Unit (RDU) Beep Level

RDU Beep sets the volume level for the keypad confirmation tones of the

RDU. Choose from low, high or off RDU beep level volumes.

RDU Display Color

RDU screen color theme is customizable to match your personal preference

or your vehicle’s dash illumination. Choices include Multi-Color, Red, Blue,

Orange or Green. Factory setting is Multi -Color.

XRS_R7_R9G_1-5-07.qxd:Layout 1 1/9/07 5:15 PM Page 25

FOURTH DRAFT