User's Manual

Optional Global Position
System Locator
36
English
Optional
GPS Locator
IntelliScope
•
In conjunction with detection of a Location Based Alert, IntelliScope provides information
about the direction of the Location relative to your moving vehicle.
The following descriptions use a Photo Enforced location as an example. In Caution
Areas and User Locations their signal icons and related text will substitute for the
Photo Enforced ones shown in these examples.
Three screens will sequence on the display to identify the type and direction of the
location generating the alert. The continuous part of the sequence will repeat as long
as the alert is active.
Screen Sequence In Zone 1 For Location Straight Ahead
As a location is approached, the arrows will point to the location while
alternating with the alert icon and text as shown in the sequence below.
The sequence will repeat as long as the alert is active.
Begin Alert
Continuous Alert
IntelliScope Alert Arrow Sequence For A Location Directly Ahead
While approaching a Photo Enforcement Location on your route that is
directly ahead.
NOTE The arrow disappears in Zone 3 when you are close to the Location.
Zone 1
Zone 2 Zone 3
Installation
Your Detector
Nothing Comes Close to a Cobra
®
5
1. Place the detector on the dashboard to find a location
where the unit has a clear view of the road and is parallel
to the road's surface. The angle CANNOT
be adjusted after mounting.
2. Remove the paper backing
from one side of the hook-
and-loop fastener.
3. Attach the pad to the
dashboard at your chosen
location and remove the
other paper backing.
4. Attach the detector to the
hook-and-loop fastener.
You can remove and
reattach the unit as
often as you like.
5. Plug the power cord
into the detector.
6. Plug the cigarette lighter
adapter on the power
cord into your vehicle’s
cigarette lighter.
Dashboard Mounting
Body.qxd 8/29/08 10:00 AM Page 5