User's Manual

Installation
Your Detector
4
English
1. Attach the rubber
cups to the bracket.
2. Make sure the rubber cups and your windshield are clean.
3. Push the bracket firmly
onto the windshield.
4. Attach the detector to the
bracket. Check that the
unit is parallel to the
road's surface.
5. To adjust the angle if
necessary, gently push or
pull on the bracket to bend
it. DO NOT use the detector
to bend the bracket.
6. Plug the power cord
into the detector.
7. Plug the cigarette lighter
adapter on the power
cord into your vehicle’s
cigarette lighter.
8. You can temporarily remove the detector whenever you
wish by depressing the bracket release button and sliding
it off the bracket.
Windshield Mounting
Optional Global Position
System Locator
Nothing Comes Close to a Cobra
®
37
Optional
GPS Locator
IntelliScope Alert Arrow Sequence When You Turn Toward The Location
While approaching a Photo Enforcement Location involving a turn onto a
cross street where it is located.
NOTE The arrow disappears in Zone 3 when you are close to the Location.
Zone 1
Zone 2 Zone 3
IntelliScope Alert Arrow Sequence When A Location Is Off Your Route
While approaching and passing a Photo Enforcement Location that is some
distance away to the right of your route.
NOTE The signal never enters Zone 3 since you never come close to the Location.
Zone 1
Zone 2
Vehicle
Turns
Right
Body.qxd 8/29/08 10:00 AM Page 4