User's Manual

Settings
Your Detector
10
English
What to Remember While Using IntelliMute
IntelliMute works with both City and Auto Mute modes.
Whenever your engine revs are below the activation point,
the dot next to the large character on the right side of the display
will remain lit. Above the activation point, the dot will blink twice
every two seconds.
If, for any reason, the unit stops sensing your engine’s revs,
IntelliMute will indicate an error and automatically turn Off.
The rev point you set will be stored in the unit’s memory when
power is turned Off and recalled each time the power is turned On.
NOTE
The rev point must be reset if you use your detector in a different vehicle.
NOTE
When initially choosing your IntelliMute activation point, a setting
of approximately 300 to 600 RPMs above idle is recommended.
You can reset the activation point at any time to fit your individual
preferences and driving style.
Setting the IntelliMute Activation Point
Your detector must be installed in your vehicle.
CAUTION
Do not attempt to set the rev point while driving.
Your vehicle should be parked and idling.
IntelliMute must be turned On before setting the activation point. Depending
on whether the unit is in Tone Alert or Voice Alert mode, you will hear a
series of beeps or voice messages as you follow the steps on page 11.
Below Activation Point
X K Ka V S
c
Above Activation Point
X K Ka V S
c
Detection
Your Detector
Nothing Comes Close to a Cobra
®
15
Radar Signals, Voice and Visual Displays
Type of Signal Voice Visual Display
X Band Radar X Alert X and Signal Strength
K Band Radar K Alert K and Signal Strength
Ka Band Radar Ka Alert Ka and Signal Strength
Ku Band Radar Ku Alert X K and Signal Strength
Laser Signal Detected
X K Ka V S L
Laser Signals, Voice and Visual Displays
Type of Signal Voice Visual Display
LTI 20-20* Laser Alert L is Steady
LTI Ultra-Lyte* Laser Alert L is Steady
Kustom Signals ProLaser* Laser Alert L is Steady
Kustom Signals ProLaser III* Laser Alert L is Steady
* Your detector provides 360˚ detection of these signals.
NOTE
Beep rate changes with different laser alerts.
During Safety Alert and Strobe Alert the letter S will appear. It will be
steady during a Safety Alert and will blink during a Strobe Alert.
Safety Alert Signal Detected
X K Ka V S
c
Strobe Alert Signal Detected
X K Ka V S
c
X Signal Detected
X K Ka V S 2
X K Ka V S 3 X K Ka V S 5 XKKa V S 4
K Signal Detected Ka Signal Detected
Ku Signal Detected
10215_XRS9440Manual_PH2_b.c.qxd 7/17/07 11:45 AM Page 10