User's Manual

Settings
Your Detector
English
Settings
•
When changing the Settings on your detector, please keep in mind:
■
Buttons can have multiple functions.
■
All settings will be stored in memory when the power is
turned Off and recalled when the power is turned back On.
Highway/City Mode
Setting your detector to City mode delays all X band audio alerts until
the signal strength reaches Level 3. (A single beep will sound when the
signal is first detected.) This will reduce false alerts while you are driving
in, or near, urban areas where there are many sources for conflicting
X band signals such as microwave towers and automatic door openers.
To change settings, follow the procedure listed below, which indicates
what you will see and hear as you complete each step. The factory setting
is Highway mode.
6
City Button
Press and
release
City Mode
X K Ka V S
c
Highway Mode
X K Ka V S h
To Change From Highway Mode to City Mode
Press and release
the City button.
Tone
Visual Display
One beep
c
appears in the display
To Change From City Mode Back to Highway Mode
Press and release
the City button again.
Tone
Visual Display
Two beeps
h appears in the display
Maintenance
Your Detector
Nothing Comes Close to a Cobra
®
19
Maintenance
•
Maintenance of Your Radar Detector
Your detector is designed and built to give you years of
trouble-free performance without the need for service.
No routine Maintenance is required.
If your unit does not appear to be operating properly,
please follow these troubleshooting steps:
■ Make sure the power cord is properly connected.
■ Make sure the socket of your vehicle’s cigarette lighter
is clean and free of corrosion.
■ Make sure the power cord’s cigarette lighter adapter
is firmly seated in your cigarette lighter.
■ Check the power cord fuse. (Unscrew the ribbed end cap
of the cigarette lighter adapter and examine the fuse.
If required, replace it with a 2-amp fuse only.)
10214_XRS9340_PH2_b.c.qxd 7/17/07 10:33 AM Page 6