User's Manual

Detection
Your Detector
English
14
Radar Signals and Visual Displays
Type of Signal Visual Display
X Band Radar X and Signal Strength
K Band Radar K and Signal Strength
Ka Band Radar Ka and Signal Strength
Ku Band Radar X K and Signal Strength
Laser Signal Detected
X K Ka V S L
Laser Signals and Visual Displays
Type of Signal Visual Display
LTI 20-20*
L
is Steady
LTI Ultra-Lyte*
L
is Steady
Kustom Signals ProLaser*
L
is Steady
Kustom Signals ProLaser III*
L
is Steady
* Your detector provides 360˚ detection of these signals.
NOTE
Beep rate changes with different laser alerts.
X Signal Detected
X K Ka V S 2
X K Ka V S 3 X K Ka V S 5 XKKa V S 4
K Signal Detected Ka Signal Detected
Ku Signal Detected
Settings
Your Detector
Nothing Comes Close to a Cobra
®
11
IntelliMute Button
Press and hold for
two seconds
To Set the IntelliMute Activation Point
Press and hold
the IntelliMute
button for two
seconds.
Tone Visual Display
Two beeps None
Rev your engine to
the level you wish
to set (recommend
slightly above idle)
and hold revs steady
for two seconds.
None Three bars will
flash in succession
At the desired
rev level, press
and release the
IntelliMute
button.
Three beeps All three bars flash
three times
Tone Visual Display
Four beeps
E
appears
X K Ka V S E
123
123
NOTE
If the unit is unable to sense usable pulses within three
seconds or if you do not set a rev point within 20 seconds
of beginning these steps, IntelliMute will indicate an error
and automatically turn Off.
10214_XRS9340_PH2_b.c.qxd 7/17/07 10:33 AM Page 11