User's Manual

Settings
Your Detector
10
English
What to Remember While Using IntelliMute
IntelliMute works with both City and Auto Mute modes.
Whenever engine revs are below the activation point, an arrow
pointing down will appear in the display. Above the activation point,
an arrow pointing up will appear.
If, for any reason, the unit stops sensing your engine’s revs,
IntelliMute will indicate an error and automatically turn off.
The rev point you set will be stored in the unit’s memory when
power is turned off and recalled each time the power is turned on.
NOTE
The rev point must be reset if you use your detector in a different vehicle.
NOTE
When initially choosing your IntelliMute activation point, a setting
of approximately 300 to 600 RPMs above idle is recommended.
You can reset the activation point at any time to fit your individual
preferences and driving style.
Setting the IntelliMute Activation Point
Your detector must be installed in your vehicle.
CAUTION
Do not attempt to set the rev point while driving.
Your vehicle should be parked and idling.
IntelliMute must be turned on before setting the activation point. Depending
on whether the unit is in Tone Alert or Voice Alert mode, you will hear a
series of beeps or voice messages as you follow the steps on page 11.
Below Activation Point
ih
Above Activation Point
ih
Detection
Your Detector
Nothing Comes Close to a Cobra
®
15
X Signal Detected K Signal Detected Ka Signal Detected
Radar Signals, Voice and Visual Displays
Type of Signal Voice Visual Display
X Band Radar X Alert X and Signal Strength
K Band Radar K Alert K and Signal Strength
Ka Band Radar Ka Alert Ka and Signal Strength
Ku Band Radar Ku Alert Ku and Signal Strength
Laser Signals, Voice and Visual Displays
Type of Signal Voice Visual Display
LTI 20-20* Laser Alert Laser 20/20
LTI Ultra-Lyte* Laser Alert Laser UltraLyte
Kustom Signals ProLaser* Laser Alert Laser Pro Laser
Kustom Signals ProLaser III* Laser Alert Laser Pro Laser 3
* Your detector provides 360˚ detection of these signals.
NOTE
Beep rate changes with different laser alerts.
X2
-
--
K-3
-
--
---
-
-
_
--
Ka ---5
---
----
----
_
Ku Signal Detected
_
-
Ku --4
--
---
----
LTI 20-20
Laser
20/20
LTI Ultra-Lyte
Laser
UltraLyte
Kustom Signals
ProLaser
Laser
Pro Laser
Kustom Signals
ProLaser III
Laser
Pro Laser 3
10216_XRS9540_PH2.qxd 8/7/07 1:28 PM Page 10