User Manual

English
Mode Functions
10
Privacy Code Scan
•
Your microTALK
®
radio can automatically scan the Privacy Codes
(00 through 38) within one (1) channel.
To Scan Privacy Codes:
1. While in Standby mode, press the Channel
Up or Channel Down button to choose
the channel on which you wish to scan
privacy codes.
2. Press the Mode/Power button until the Scan
icon and the privacy code numbers flash on
the display.
3. Press the Channel Up or Channel Down
button to begin scanning privacy codes
within the channel you selected.
The Scan icon will continue to be displayed
when privacy code scan is On. Your radio will
continue to scan privacy codes and stop as an
incoming transmission is detected. Your radio
will remain on that channel/privacy code for
ten (10) seconds.
While setting privacy code scan, if you do not
press any buttons for 15 seconds, your radio
will automatically return to Standby mode on
the channel/privacy code that was displayed
before you entered mode functions.
Operation
Channel Button
Mode/Power Button
Select Channel
Scan Privacy Codes
Customer Assistance WarrantyIntroduction Operation
7
Nothing comes close to a Cobra
®
Scrolling Through The Mode Function
•
By scrolling through the Mode function, you will be able to
select or turn On preferred features of your microTALK
®
radio.
When scrolling through the Mode function, your radio features
will be displayed in the same predetermined order:
Set Privacy Code
Set Channel Scan
Set Privacy Code Scan
Set Call Tones
Set Roger Beep On/Off
CTCSS Privacy Codes
•
CTCSS (Continuous Tone Coded Squelch System) is an advanced
tone coding system allowing you to select one of 38 privacy codes
to reduce interference from other users on the channel.
If you are using a privacy code, both radios must
be tuned to the same channel and privacy code to
communicate. Each channel will remember the last
privacy code you selected.
To Select A Privacy Code:
1. After selecting a channel, press the Mode/
Power button until the small numbers next
to the channel number flash on the LCD.
2. Press the Channel Up or Channel Down
button to select a privacy code. You can
hold the Channel Up or Channel Down
button for fast advance.
3. When your desired privacy code is displayed:
a. Press the Mode/Power button to enter the
new setting and proceed to other functions.
b. Press the Lock button to enter the new
setting and return to Standby mode.
c. Do not press any buttons for 15 seconds
to enter the new setting and return to
Standby mode.
Privacy Code
Mode/Power Button
Channel Button
Mode/Power Button
Job: 245.qxd -- Color: Composite -- Signature 1, Sheet 4, Front -- Plate 7