Specifications

©
ARCO STARTING & CHARGING SPECIALISTS
TOLL FREE 800-722-2720 • PHONE: [phone] • FAX: [phone] • WWW.ARCOMARINE.COM
3
Cutting a unit’s wires or dismantling a unit immediately voids the manufacturer’s warranty. In addition, taking a
motor off the reservoir and trying to install it on an old reservoir usually damages the brushes and seals in the
motor. Disassembled parts are not covered by warranty.
A broken flange is typically caused by improper installation. The mounting holes may look evenly spaced in a triangular
pattern, but they are not—one hole is slightly offset. Forcing a mounting bolt into the offset hole may cause the
flange to break. This may also occur if the mounting bolts are not tightened evenly. A broken shaft is caused by a
malfunction in the gearbox. These breaks are not material defects, and they are not covered by warranty.
This type of failure is always blamed on a bad casting, defective drive gear or internal gears. In fact, it is caused
when a starter, spinning at a high rate of rpm, comes to an abrupt stop. This can occur when an engine backfires
or momentarily releasing the start switch and re-engaging the starter before it has spun down. It may also hap
-
pen when a cylinder suffers a water hydraulic lock. In either case, the damage is not due to a defective part, and
is
not covered by warranty.
The solenoid was not broken when the starter was packaged to be shipped. We have special boxes made for
the starters, and we use special packing materials to ensure the item will arrive to the customer safely. Some-
times, though, the packages are mishandled by the carrier (i.e., dropped or thrown) and the solenoid becomes
damaged. This is the carrier’s responsibility. It is not a material defect; therefore it is not covered by warranty.
part boxes are not shipping boxes.
If you are shipping a part to a customer or
sending a warranty return, the part must be
packaged in a way to prevent possible damage.
Place extra packing material around the part,
place it back in the part box and then into a well
packed, sturdy shipping container.
To prevent damage, properly pack all parts before reshipment.
treats every component with a special rust and corrosion resistant coating to prevent water damage.
However, it is impossible to protect the unit from direct contact with water. Therefore, a failure directly caused
by rust, corrosion or submersion is not covered by warranty.
FREIGHT DAMAGE
BROKEN SOLENOIDS
RUST, CORROSION OR SUBMERSIONS
BROKEN MOUNTING FLANGES OR SHAFTS
CUT WIRES OR DISMANTLED UNITS
BROKEN NOSE HOUSINGS, DRIVE GEARS OR INTERNAL GEARS
WARRANTY INFORMATION
An ARCO Warranty Protects You From Defects in MATERIALS OR WORKMANSHIP…
The Warranty DOES NOT cover such things as: