User manual

4625 - 4627 USER MANUAL

7. - DRIVER CARD (optional) BATTERY REPLACEMENT.

The Driver Card battery is a CR2032-3V lithium battery.

When the Driver Card battery is low the emergency panel LED ﬂ ashes for 10 times. If the system doesn’t disarm when the

Driver Card is inside the vehicle try to disarm it by pressing the Driver Card pushbutton, otherwise replace the battery.

• To change the battery, open the Driver Card shell, being careful to lever it up at the point the area indicated in the drawing.

• Remove the battery by extracting it in the manner shown.

• Wait approximately 10 s.

• Insert the new battery, taking care to make sure your ﬁ ngers touch it only on the sides. Make sure its polarity is correct, as

indicated in the diagram.

• Close the shell and press the Driver Card button checking that the system responds correctly. Perform the test near the

vehicle.

• Dispose of the empty battery in an appropriate disposal - bin.

• In the event of loss of both the Driver Cards an emergency disarming may still be performed. Reference should be made

to the disarming / emergency procedure described in step 5.