User manual

12
USER MANUAL 4625 - 4627
6. - COBRA REMOTE CONTROL (optional) BATTERY REPLACEMENT.
The Cobra remote control battery is a CR2032-3V lithium battery.
Its replacement is necessary as soon as, by pressing one of the two pushbuttons, the LED fl ashes irregularly or just for
a short time.
To replace the battery perform the following steps:
• open the remote control shell, being careful to lever it up in the point indicated in the drawing.
• Remove the battery as shown (dispose the empty battery in the appropriate container disposal).
• Wait approximately 10 seconds, then insert the new battery, taking care to make sure your fi ngers touch it only on the
sides. Make sure the polarity is correct, as shown in the drawing.
• close the shell and press the remote control pushbutton “A” to check if the system is properly working.