User manual

25
3. The 3 pin Lemo spur protruding from the PA to Bodywire
adaptor cable, should be connected to the PA to provide power
and PA enable.
DC Power and Control Cable
The SOLAMP is powered by the SOLO4 Bodywire TX and no additional
power is required. However the voltage range when using the SOLAMP
is more limited.
• Input Voltage Range: 11-16V, reverse voltage protected.
• Current Draw 1.2A (Includes SOL2/SOL4 TX) at 12V.
Antennas
Domo SOLAMP is supplied without antennas as standard. It is good
practice to ensure that an antenna is always connected before powering
the device. Prolonged operation without an antenna is not
recommended. The antenna should be connected by screwing it to the
TNC Type output connector with adapters as required, but care should
be taken not to over-tighten.
Note: It Is recommended that where possible antennas should be connected directly to the
SOLAMP. Use of cables will degrade performance.