User manual

Approximately 2 hours should be allowed for a full charge of the

SOLBAT battery.

1.4 Using the Clip On 1W Amplifier

Additional range can be achieved by connecting the SOLAMP1W clip

on amplifier to the domo Bodywire transmitter.

Connections

This section describes how to connect the following model numbers.

• SOLAMP1W

The domo SOLAMP1W is supplied with the following cables:

• RF Cable (SMA to SMA semi-rigid bridge cable)

• DC Power Cable (with Control breakout)

• Lemo to Dtype control cable

• PA to Bodywire adaptor cable

Amplifier Connection

The domo SOLAMP1W is designed to mount directly onto the

SOL4/SOL2 transmitter. It will not mount directly to the SOLO4

Bodywire, to achieve connection following steps should be taken.

1. Connect the RF output of the transmitter (SMA) to the RF input

of the amplifier (SMA) using the short semi rigid SMA cable

provided. The SOLAMP is designed to work directly with the

SOL2/SOL4 transmitter.

2. Connect the PA to Bodywire adaptor cable inline, between the

15way DType female on the bodywire and the 15way DType

male on the CA317 Break Out cable.