User manual

Chapter 4: Using the web interface
98-129217-C Setting up the interfaces 82
Configuring the Phone/Fax interface
To configure the Phone/Fax interface do as follows:
1. Select SETTINGS > Phone/Fax from the left navigation pane.
2. If you have additional numbers from your airtime provider and you want to assign them to the
Phone/Fax port, use the Assigned number drop down list to select the number you want to
use.
When this number is called, only the handset connected to that port will ring.
3. Set the call type for incoming and outgoing calls.
The call types are described in more detail in Selecting the call type on page 26.
•For Incoming calls, you can select Standard or 3.1 kHz Audio or both.
If you select both, any device connected to the Phone interface will react (ring) on incoming
calls.
If you select e.g. Standard, the Phone interface will only react on calls made to the Standard
phone number.
•For Outgoing calls, you can select either Standard or 3.1 kHz Audio. The selected type will be
used by default, if possible, for any outgoing call. Note, however, that fax machines must
use 3.1 kHz Audio.
4. Click Apply.
Note
To be able to use the additional numbers, you must first
select Use additional numbers in the Multi-voice page and
enter the additional numbers under PHONE BOOK > Mobile
numbers. See Multi-voice on page 120.
Note
You can override the default setting for outgoing calls by dialling 1* (force the call to
Standard) or 2* (force the call to 3.1 kHz Audio) before the number. For further
information, see Overriding the default outgoing call type on page 27.