User manual

Chapter 4: Using the web interface
98-129217-C Setting up the interfaces 76
12. Follow the instructions in the warning and set the Default group to No Internet access, if you
are going to use the Bridge mode connection.
For details on how to set up the Default group, see Setting up the Default network user group
on page 71.
13. Select SETTINGS > LAN > Network classification.
The network classification table is used to define which network devices, IP addresses and/or
LAN ports are associated with which network user groups.
14. Click Add to include Group 0 (Bridge mode) in the list.
15. Select or type in the parameters you want to associate with your Group 0.
MAC address: If you want only a specific device (MAC address) to belong to Group 0, you can
do one of the following:
• If the device is or has been connected to the terminal, locate the device in the list at the
bottom of the page and click Add next to the device.
• Type in the MAC address in the MAC address field at the top of the page. An asterisk
indicates a “wild card”, which means any MAC address is accepted.
IP address: If you want a specific IP address to belong to Group 0, type in the IP address in the
IP address field. If the field is left empty, any IP address is accepted.
LAN port: If you want devices connected to a specific LAN port to belong to Group 0, select the
port number to use.