User manual

Chapter 4: Using the web interface
98-129217-C Setting up the interfaces 97
Configuring the I/O interface
To configure the I/O pins, do as follows:
1. Select SETTINGS > Discrete I/O.
2. For each pin you want to use, select Enabled.
3. For each pin, select the function of the pin. Refer to the previous section, I/O pins and their
functions on page 95.
4. If you are using the Ignition function and you want the terminal to stay on for a few minutes
after the Ignition is switched off, enter the number of minutes under DELAYED SHUTDOWN.
For further information on the Ignition function, see Using the ignition system on page 13.
5. If you are using a ringer output, select the incoming call types that should activate the ringer
under RINGER OUTPUT.
6. If you are using a Mute output, select the call types (both incoming and outgoing) that should
activate the Mute function under MUTE OUTPUT.
7. Click Apply.