User manual

Chapter 4: Using the web interface
98-129217-C Setting up the interfaces 93
Setting the call types for IP handsets
In the Call settings page you can set the call types for each local number and see whether
Restricted dialling is enabled for that number. For further information on Restricted dialling, see
Restricted dialling on page 119.
To set the call types for IP handsets, do as follows:
1. Select SETTINGS > IP handsets > Call settings.
2. If you have additional numbers from your airtime provider and you want to assign them to the
IP handsets, use the Assigned number drop down list to select the number you want to use for
each handset.
When this number is called, only the assigned handset will ring.
3. For each handset, select the call types you want to enable for incoming and outgoing calls.
The call types are described in more detail in Selecting the call type on page 26.
•For Incoming calls, you can select Standard or 3.1 kHz Audio or both.
If you select both, the handset will react (ring) on any incoming call.
If, for example, you select Standard, the handset will only react on calls made to the
Standard phone number.
•For Outgoing calls, you can select either Standard or 3.1 kHz Audio. The selected type will be
used by default, if possible, for any outgoing call.
4. Click Apply.
Note
To be able to use the additional numbers, you must first
select Use additional numbers in the Multi-voice page and
enter the additional numbers under PHONE BOOK > Mobile
numbers. See Multi-voice on page 120.