User`s manual

100-M0171X3 8 of 95
GMS Inc. doing business as Cobham Tactical Communications and Surveillance
www.cobham.com/tcs
5. Do not substitute any antenna for the one supplied or recommended by the
manufacturer. The installer is responsible for ensuring that the proper antenna is installed.
6. It should be noted that this device is an intentional radiator, hence:
Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
NOTE: The manufacturer is not responsible for any radio or TV interference caused
by unauthorized modifications to this equipment. Such modifications could void the
user’s authority to operate the equipment.
7. DC power (+12VDC nominal) to the unit should never be applied until the antenna (or other
suitable load) has been attached to the device SMA RF output connector. Safe operating
procedures must be observed when unit is transmitting into an antenna (see sections 1 &2
above).
8. Electro-Static Discharge (ESD) precautions should be observed as a safe practice.
9. The transmitter will generate considerable heat and is the responsibility of the end user to
properly heat sink the device before using.