User`s manual

100-M0171X3 55 of 95
GMS Inc. doing business as Cobham Tactical Communications and Surveillance
www.cobham.com/tcs
Taking into account that the Video stream is the fundamental constituent of the Transport
Stream keep the following guidelines in mind when changing individual parameters.
a) If a dual stream/program is active and the Video 1 Input Mode under the VIDEO tab is
turned OFF (OFF selected from the pull down box) the corresponding Audio 1 Input
Mode (under the AUDIO tab), the corresponding Aux Data 1 under the Aux Data tab
and the corresponding Program 1 under the TS tab are all disabled at the same time.
b) With the condition stated above under (a), if the Video 1 Input Mode in a dual
stream/program is re-activated (enabled) the corresponding Audio 1 Input Mode
(under the AUDIO tab) remains disabled (OFF). However the corresponding Aux
Data 1 under the Aux Data tab and the corresponding Program 1 under the TS tab are
re-activated (enabled if they were previously), keeping in mind because audio is OFF, the
audio PID is grayed out under the Program 1 of the TS.
c) Similar conditions as stated in (a) and (b) also apply when using a single stream/program.
That is if Video 1 Input Mode is active and it is switched over to Video 2 Input Mode the
corresponding Audio 1 Input Mode (under the AUDIO tab), the corresponding Aux
Data 1 under the Aux Data tab and the corresponding Program 1 under the TS tab are
all disabled at the same time. And as stated under (b) if Video 1 Input Mode is re-
activated the corresponding Audio 1 Input Mode (under the AUDIO tab) remains
disabled (OFF). However the corresponding Aux Data 1 under the Aux Data tab and
the corresponding Program 1 under the TS tab are re-activated (enabled if they were
previously), keeping in mind because audio is OFF, the audio PID is grayed out under the
Program 1 of the TS.
d) If Video 1 Input Mode is ON (and /or Video 2 Input Mode in a dual program/stream) and
the corresponding Audio (Audio 1 and/or Audio2) Input Mode is OFF the corresponding
Audio PID in the Program (Program 1 and/or Program2) in the Transport Stream under
the TS tab is automatically turned OFF (grayed out).
e) Under the Streaming tab, the selection of Streaming In forces the Transport Stream
Source under the TS tab from INTERNAL to STREAM IN.
f) If Streaming In is currently selected (under the Streaming tab) and if INTERNAL is
selected as the Transport Stream Source (under the TS tab) then Streaming OFF is
automatically selected (under the Streaming Tab).
g) If Stream IN is selected as the Transport Stream Source under the TS tab all functions
except for the RF parameters under the RF tab, the Streaming IN parameters under the
Streaming tab and the ASI Out Control under the TS tab are disabled.
h) If ASI (ASI 1 or ASI 2) is selected as the Transport Stream Source under the TS tab the
corresponding Video Input Mode (Video 1 or Video 2) under the Video tab is shown as
ASI. If in a dual program/stream mode the second Video Input Mode is OFF.
i) If Streaming In is selected as the Transport Stream Source under the TS tab, the
corresponding Video Input Mode is set to OFF (Video 1 Input Mode is set to OFF and in
case of a two stream/program Video 2 Input Mode is also disabled). If Streaming In is
then set to Streaming OFF, the Video 1 Input Mode remains OFF, however Video 2
Input Mode is then the active video in the case of a single stream/program. In the case